I have a call manager with a 6608 PRI gateway. Customer's PRI service is from ATT 4ESS. ATT wants the call-by-call NSF service set to Megacom. Calls can not be made if this info is missing in the D channel set-up message.
I've seen this set on IOS routers but not on CAT switches.
Can this work with a 6608 gateway or does something need to change?
I had this setup for a few clients of mine. I had to have the Megacom Tech setup the Megacom PRI for STATIC channel assignment. Basically what I ended up doing was getting a guy from AT&T local service on the phone with a guy from AT&T megacom and asked them what the difference was between an AT&T local PRI (which worked) and an AT&T megacom PRI...after a lenghy discussion what we found out is that the megacom PRI uses dynamic channel assignments (call by call) and the local PRI uses a static set (same with every other vender). We had the megacom tech reconfig the Megacom PRI to use static and it worked great.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...