Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Attendant Console Hold Time

We have enabled Queuing for Attendant Console in broadcast mode. We wanted to change the hold time default value to a longer time, but it seems to go back to default value of "0". Is there way to make that change permanent, so we could have a longer hold time than the default? Thanks.

1 REPLY
New Member

Re: Attendant Console Hold Time

I am guessign you are using the ACConfig.bat files on the CallManager to change this time.

Make sure to save it and restthe TCd services. That shoudl take care of it, if not probaly you have to open a TAc case

p.s: Rate it when ti helps

105
Views
0
Helpful
1
Replies
CreatePlease login to create content