How do you get the first line in an auto attendant hunt group to roll to the next number? I've got a pilot point set, it rings in to the first hunt group member and then goes strait to his voicemail every time. It never rings member #2's extension. Is there some trick I'm missing here? Thanks...
No, they can, but the hunt groups follow the forwarding paths as set on the phones. If a phone in a hunt group forwards ring-no-answer to voice mail, then that's where the calls will go. My misunderstanding was that I thought the Call Manager performed some sort of supervision of these hunt group calls, and would retrieve them from busy/no answer stations. That's not how it works.
In your subject you say attendant console (AC also known as TCD) but in your post you say auto attendant. I only know of hunt groups with AC so I am going with that application.
TCD has a service parameter "allow routing on unknown line state". When true, if TCD does not know the line state of the huntgroup members, it will try to route first available through the huntgroup.
TCD might not be receiving line state because the CCM service parameter "line state update enabled" is set to false. If you have to change this to true, it requires a restart of the CCM service to take effect.
Otherwise, please configure detailed TCD tracing and post the section of the trace that shows routing the call to the huntgroup member.
AC does not have the ability to "take back" calls from hunt group members. If a call is routed to a huntgroup member, then AC releases the call and it follows the CFNA destination configured for the huntgroup member.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...