Attendant Console - Initialisation of Call Control Failed.
I get the above error message when I try to log in to an AC that I just set up. I use a non defualt udername and password and I am sure that I have set-up everything OK - followed the manual. I noticed that the receptionist uses the default AC/AC12345 username and password config. When I use this login config on the AC that I just set-up all I don't get the above error message!?
Re: Attendant Console - Initialisation of Call Control Failed.
The AC user is not the user that the receptionist should use for longing in. You should set her up as her own login and associate the device the at attendant console will control. Then login in with the new account
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...