Does anyone know of a third party app that will give Call Manager the ability to use authorization codes for long distance/international calls and have the call logged to a CDR so it can be billed back?
9.1xxxxxxxxxx if your code is 2222 then it will be 92222.1xxxxxxxxxx the end user will have to dial 922221xxxxxxxxxx.
point that at a route list. do not do any digit strip on the route pattern, but do a pre-dot digit strip on the route list. this will insure that the access code is inserted into cdr. If you digit strip on the route pattern, only the outgoing phone number is logged.
You can create a RP for each code, or generalize them with wildcards like this-
92xxx.1xxxxxxxxxx just make sure it won't overlap with any of your other RPs.
This is fairly easy to imeplement, and will track usage, unfortunately it will also show the access code in the placed calls directory on the phone, and it is fairly easy to guess the code, because CM will let you try as many combos as you want without locking it out.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...