Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Auto Assign ATA186 in CME

Has anyone tried the auto assign feature in CME with the ATA and got it to work ?

Phil

3 REPLIES
New Member

Re: Auto Assign ATA186 in CME

Basically, you assign an unused ephone and an ephone dn. As long as you have the ata firmware on flash, it should automatically assign the ephone dn to the ata. Also, if you want the 2nd analog port to register, just create another unused ephone/ephone-dn. It worked great for me.

New Member

Re: Auto Assign ATA186 in CME

Not sure I follow you here. I was referring to the "auto assign" command http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/products_command_reference_chapter09186a00801c59f5.html#1024484 which automatically assigns ephone-dn's when phones register. The ATA does not seem to behave like an IP phone, although the command has "ata" as a choice for the "type" keyword.

New Member

Re: Auto Assign ATA186 in CME

Sorry...What I was saying was I got my ATA adapters to register without using the auto assign command. I simply used the process I stated before, and the ATA's came up automatically...both ports! CM is not even that easy.

113
Views
0
Helpful
3
Replies