Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Auto dial 2nd.line

Have 3 7940 phones W/same line (2) appearences.When 1st line is off-hook all phones get correct indications.

When a 2nd phone tries to auto-dial a number (dials a number then press "dial" softkey)Display says "line in use."Is there a way to choose the 2nd line to make call without directly accessing the line?

CCM 3.3.5 Sr1

7940 phoneload P00307020200

Thanks in advance.

  • Other Collaboration Voice and Video Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Auto dial 2nd.line

Under the advanced Callmanager parameter - "Always use Prime Line" in the "Clusterwide Parameters (Device - Phone)"

Make it false.

1 REPLY
Silver

Re: Auto dial 2nd.line

Under the advanced Callmanager parameter - "Always use Prime Line" in the "Clusterwide Parameters (Device - Phone)"

Make it false.

113
Views
0
Helpful
1
Replies
This widget could not be displayed.