I have some Vertical IP Phones which connects to Cisco 3560 Switches. Currently there is no QoS configured. I have added the following two commands on all interfaces mls qos trust dscp and priority queue out
Also added the command "auto qos voip cisco-phone" on interfaces where Phones are connected.
I came to know that, since its not Cisco Phones, we can configure command "auto qos voip trust" instead of auto qos voip cisco-phone. Does it make any difference ?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.