From what I see, auto qos on a 6500 is only available in CatOS. I need to configure a 6500 IOS with the equivalent of "auto qos trust" on interfaces connected to other switches. I also need the global commands too. Any guideance on this matter will be appreciated. I was also looking for the document that tells how packets coming into the Communication Media Module from the PSTN are marked for QOS. I saw it once. It said you had to map COS to DSCP on the corresponding switch.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.