Recently moved from a 3750 switch configured with auto QoS to a 4506 now configured with auto QoS, however we are now having issues with the UCCX call recording initiated by agents in CAD, the quality is extremely poor, it was fine before when agents were on the 3750. The UCCX server is at another site located over a WAN link.
I have attached a snapshot of the 2 configs from both switches, showing the qos config generated, any help would be appreciated.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...