Here's what I'm trying to setup. A phone auto-register's to CCM and when the person picks up the handset it PLAR's to the helpdesk number...say 4000. I have a autoreg partition, an autoreg CSS with only the autoreg part in it. Then I have a trans pattern created with a blank translation pattern that is in the autoreg part, then i have a CSS on there that can access the number i have in the called party transform mask. When a phone auto registers, and I go off hook, it does not PLAR. However if I go into that phone and apply a CSS to it (either device or line), and then go off hook it PLAR's perfectly.
there is a PT assigned to auto reg. That PT belongs to a CSS that has access to the PT that 4000 belongs to. However it does not ever work until I apply that CSS to the line or device CSS of the phone. In other words, it doesn't work with only partition info on the auto registered phone.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.