Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AutoQoS error

Hello,

I am trying to enable autoqos on a mlppp connection. It doesn't take the command on the Multilink1 interface, so I thought I would try to apply it on the two serial interfaces running mlppp. I get this error when I try to enable it:

AZ-INTERNET(config-if)#auto qos voip

AutoQoS Error: the following command was not properly applied:

service-policy output AutoQoS-Policy-UnTrust

Does anybody know what this could mean?

thank you

2 REPLIES

Re: AutoQoS error

"auto qos voip" is not currently supported under existing multilink interfaces bundling

high speed serial interfaces. However, you can take advantage of the auto qos

configuration feature and apply the auto-generated policy-map to the multilink interface

manually

New Member

Re: AutoQoS error

Thank you,

I am just going through and creating custom qos policies because we don't use cisco voip equip anyway. So autoqos probably wouldn't have worked.

thanks for the reply

183
Views
0
Helpful
2
Replies
CreatePlease login to create content