AvDirSynch_MC Error after Service Account p/w change
We recently changed our Exchange Service Account password by following the tech tip Cisco provides. Since that time the account periodicly is getting locked out. I think I've tracked it down to the unity server and specificly the event log below. Is there a way to change the account information for these LDAP synchronization cycles? I've been looking around both here and on the net in general, but have not found anything relevent. Unity is 3.0(3) Exchange is 5.5.
Event Type: Warning
Event Source: AvDirSynch_MC
Event Category: Warning
Event ID: 1057
Time: 6:47:41 AM
Skipping synchronization cycle due to error connecting to LDAP server. Ensure that the server is accessible, Exchange services are running on the server, and the monitor service account is configured correctly.
Re: AvDirSynch_MC Error after Service Account p/w change
This could be related to a known MS issue with service accounts losing their PW association if they don't have the "log on as batch" assigned to them... a couple folks out here ran into similiar issues, however most of the time they noticed the problem on a reboot since Unity wouldn't come up afterwards since the PW in the SCM was bogus... still, worth a shot.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...