09-16-2006 08:30 AM - edited 03-13-2019 03:00 PM
According to the documentation to stop B-ACD service you enter the following commad:
Router(config)# call application session stop id 17
I don't see this as an available option in 12.4.3e. I modified "param aa-hunt3" to "param aa-hunt1" but it does not take an effect imidiately unless I reboot the router. I was hoping for an easier way.
Chris
Solved! Go to Solution.
09-16-2006 12:13 PM
Identify the session id of the queue application using:
Show call application session
then do
call application session stop id
and then:
call application voice load aa|queue
Only those parameters are failing to update?
09-16-2006 12:13 PM
Identify the session id of the queue application using:
Show call application session
then do
call application session stop id
and then:
call application voice load aa|queue
Only those parameters are failing to update?
09-16-2006 12:16 PM
I tried running this command from config mode, I guess you do it from enable mode instead.
This documenations states that it needs to be done from config t mode:
Router(config)# call application session stop id 17
Router(config)# call application session stop id 12
Thanks, this was the only parameter that I noticed which wasn't getting updated.
Chris
09-16-2006 04:12 PM
Rather than stopping the session, you can reload the files in flash using this command.
call app voice load
call app voice load
This should throw an output on command line, like "File read successfully". After this place a call and see if new settings are effective or not. It should!
09-17-2006 08:33 AM
Thanks Sankar.
Chris
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: