The procedure given above is sufficient to restore an ICM DB from scratch.
I did'nt understand the phrase "entire drive should it Fail. "
The things needed to restore an ICM DB from the start are
ICM configuration and Script data
However cisco suggests that you use fault tolerance on ICM by duplexing the ICM which virtually gives you 0 downtime in case of ICM failure. In case you cannot afford the above then you can implement redundancy by the following
Redundant Array of Inexpensive Disks (RAID) configurations
We use Harbor for our entire ICM infrastructure. We are in the process of migrating that over to Veritas. The 2 above solutions perform what you are looking for as far as backing up the entire server to some sort of solution. Hope that helps.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...