Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

bad calling number (using SRST outgoing call)

Hello,

I installed a SRST with a callmanager. Every things work find. Except when in SRST mode (CM fallback) i made a call :

The calling number receved by the other and is the internal number i use for the IP phone.

I call from IP phone n°25

so it goes :

- calling number 25

- called number 0145678912

The call is ok, just the number is not good (it must be 0144556625).

How to configure that in the call-fallback-all ?

Thank's

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: bad calling number (using SRST outgoing call)

you need to add a translation-rule to convert the 25 to the full number

eg:

Translation-rule 3

rule 0 ^2 014455662

then add the translation rule to your outgoing pots dial peer

eg:

dial-peer voice 3000 pots

translate-outgoing calling 3

hope this helps

1 REPLY
New Member

Re: bad calling number (using SRST outgoing call)

you need to add a translation-rule to convert the 25 to the full number

eg:

Translation-rule 3

rule 0 ^2 014455662

then add the translation rule to your outgoing pots dial peer

eg:

dial-peer voice 3000 pots

translate-outgoing calling 3

hope this helps

110
Views
0
Helpful
1
Replies
CreatePlease login to create content