Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bandwidth Aggregation on serial links

Hi,

How we can aggregate the bandwidth on serial links.

Thanks and Regards,

Stella Florence W

2 REPLIES
Blue

Re: Bandwidth Aggregation on serial links

if you have multiple serial links (WAN links) between sites, you can use a routing protocol to 'load balance' your traffic by packet or destination.

eigrp is good for this and ospf works well too.

see this link for eigrp:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800ca762.html

see these links for ospf:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800b3f2e.html

http://www.cisco.com/en/US/tech/tk365/technologies_white_paper09186a0080094e9e.shtml

see this link for how load balancing works:

http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094820.shtml

Re: Bandwidth Aggregation on serial links

Hi Stella

If i am not wrong you are talking about multilinking the induvidual physical links of e1/t1 capacities to get higher bandwidth.

If thats the case you can very well make use of multilink technique which helps to do that.

do refer this link for config reference..

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_configuration_example09186a00800a5efa.shtml

regds

435
Views
0
Helpful
2
Replies