Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Barge without Shared Lines

I have a potential customer that needs to be able to barge into any phone on his network. He has this functionality today on his existing PBX. There are 150 phones, so using the traditional Barge with shared-lines does not work here. He only needs this functionality from one or two specific phones. This customer will NOT use a PC-based application. I looked at MLPP and that doesn't work either. I'm stumped. Any ideas?

5 REPLIES
Silver

Re: Barge without Shared Lines

Try Bug - CSCdy61372

New Member

Re: Barge without Shared Lines

The bug is not found on the bugtool. My issue is not bug-related anyway.

Green

Re: Barge without Shared Lines

Hi Maurello,

Actually we dont have support for BARGE without shared lines.

You may look for a feature like supervision used with Contact Centers for Agents-Supervisor monitoring.

Maybe one of our IPCC experts can give u some advise.

New Member

Re: Barge without Shared Lines

Thanks for the response. Like I said in the initial question, the solution cannot be PC-based. Even if we could do supervisor listen/barge, I don't think we could roll out 150 agents just for a barge function. That would get very expensive and cumbersome.

From my research, a lot of TDM-based PBXs have a way to accomplish this. I was hoping that we could leverage the precedence and preemption of MLPP to make this work. Instead of simply kicking off the active call with preemption today, I was hoping there was some way it simply put the call on hold instead. Maybe it will end up in a future version.

Green

Re: Barge without Shared Lines

Hi tmaurello

We understand your concern,

You may contact your local Cisco SE to make a feature request u could get sth from cisco that meetsyour proyect requirements

130
Views
0
Helpful
5
Replies
CreatePlease login to create content