BAT 4.3 with CM 3.13a

[lars.nohling]

Does anyone know if I could use BAT 4.3 with CM 3.13a?

It looks like BAT 4.3 will create Device Profiles but I don't trust CM 3.2 yet.

[mimckee]

In the release notes it only says CCM 3.2(1).

http://www.cisco.com/univercd/cc/td/doc/product/voice/sw_ap_to/admin/bulk_adm/4_3_1/bat43ch1.htm#xtocid1

You can only get it by load CCM 3.2(1) in the first place.

Thank you,

-Mckee

[dgoodwin]

Generally speaking, BAT is forward compatible only with CallManager versions, not backward compatible. In other words:

BAT 4.2 works with CM3.1 and higher

BAT 4.3 works with CM3.2 and higher

[dcharlier]

I tried to do a setup in our lab. You will get the following message : "please upgrade to CCM 3.2 or later, aborting setup"

[mimckee]

I think you are going to have to wait until you upgrade to 3.2(1) of Cisco CallManager.

Thank you,

-Mckee