I am trying to add a 100 7940 to cm using BAT, I want the 2nd line on the device to be a service URL, I have assigned a phone button template which has a service URL , I can not see any option in BAT to update the service url
I believe there is no option to BAT the service URL because the service needs to be subscribed to the device first, which I know you can put in the phone template but I believe this multiple layer need is where BAT gets limited. I had the same issue last month. The best course of action would be to put this through to your account manager and ask for BAT Service URL updating to be added to the next release as a feature request.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...