Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

BAT/TAPS with a 7825 as the Publisher (CM 3.1)

I have a 7925 as the publisher and a 7935 as the subscriber. I installed BATs on the 7925 and TAPS on the 7935 (the CRA server). When I dial the TAPs CTI route point it goes to one of the CTI ports and then aborts. Is there a problem running bats/taps over two machines in this way?

1 REPLY
Community Member

Re: BAT/TAPS with a 7825 as the Publisher (CM 3.1)

The problem has been solved -

On instalation of the bats/taps file the Publisher ip address has to be inputted, not the ip of the box it is being installed on. The request for the address is a little missleading as it just says - 'please enter the IP addres of the CCM server'

91
Views
0
Helpful
1
Replies
CreatePlease to create content