We recently upgraded CCM from 3.3(4) to 3.3(5) and BAT to 4.4(5). Since the upgrade the EM Profiles have not been associating w/ their devices as they have in the past The order that I import the database is as follows: 1st I import the Users. 2nd I import the sets and after we cut over I import the UDP's The phones import ok but I receive the following error that I can't figure out why everything imported fine before the upgrade???
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.