Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Bearer capability configuration

Hi all,

I have the following problem:

3660 w/PRI E1 interface working as H.323 gateway, CCM 3.2(2c), multiple ATAs and IP-Phones using SCCP.

Outgoing calls from ATAs should be established with bearer cap 0x9090A3 (3.1 kHz Audio), while regular IP-Phone calls should use bearer cap 0x8090A3 (speech) for call setup.

How can I achieve this?

So far all calls are set up using bearer cap speech. I can overwrite the bearer cap to 3.1 kHz by the router (gateway) but that means that it is used for all calls.

Thanks

Gunnar

1 REPLY
Cisco Employee

Re: Bearer capability configuration

There's no way currently to do this on a per-call basis, only per voice port. There should be no problem with forcing all calls to be 3.1kHz bearer capability.

292
Views
0
Helpful
1
Replies
CreatePlease to create content