why is there a duplicate dial-peer voice 1 pots in your configuration? perhaps these had created a conflict. else the other reason would be the destination-pattern is processed prior to the translate statement.Under the translation rule,you can try removing the '9' from each rule & see if its still getting through.
I didn't do translation from one number to another number. But I am doing outgoing call blocking to PSTN, such 1900, 008 and etc. I have tried to apply on the voice-port interface, it's not working. are my patterns wrong ? such as rule x reject /^XXX*/
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.