Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

BLOCKING CALLER-ID ON A PRI 6608 GATEWAY

Is there a way to Mark calls from an individual Phone and or individual calls out a PRI off a 6608T-1 gateway as PRIVATE? The PRI does call screening for the DID or Associasted MASK to match the database. If no match it sends the billing number. The customer wants to have their collections agents number marked Private or Unknown. The PRI Provider said if the ISDN Setup String marks the call as Private the Telco will respect that and block the calling party number.

3 REPLIES
New Member

Re: BLOCKING CALLER-ID ON A PRI 6608 GATEWAY

in 3.3 there is an option in the route pattern to mark the call as private. you could set up some patterns with a few extra digits to match say *679@ then if the user dials with the *67 it will match that pattern it will mark the call as private.

hope this helps

scott

New Member

Re: BLOCKING CALLER-ID ON A PRI 6608 GATEWAY

how do you mark the call as private? Is it the same as setting the Call Presentation value to "Restricted"?

Thanks

Sudeep

Silver

Re: BLOCKING CALLER-ID ON A PRI 6608 GATEWAY

Yes, set the Calling Party Presentation to Restricted in Route Pattern or Route List config, and to Default in Gateway config.

225
Views
0
Helpful
3
Replies