I'm trying to find a way to block inbound calls from the CO from specific phone numbers. Our phone company says they can't do it on their end.
I've got CCM 3.2(2c) using a 6513 with a 6608 card as a gateway using ISDN PRI connections. TAC says there is no way to block or route calls based on the callers number in this configuration. They say the only way to do it is to have the PRI's terminate on an IOS device setup for H.323. (Changing all my hardware isn't an option!)
Any ideas on ways to do this in CallManager? Does 3.3 offer any options? I've got an ICD server if there is a way to kludge it to do this. (I only need to worry about these calls to a couple of our internal numbers.)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...