I was wondering if someone could tell me if there is a way to block outbound calls based on a phone number list without monitoring all the phones?
Here is what I am thinking:
all outbound calls will be forced to arrive at a CTI Route Point using translation table.
JTAPI will be monitoring CTI Route Point and then deciding if calls goes through or not.
What I am concerned with is:
when I use Cisco phone to dial for example 9-1-714-111-2222 where 9 is outside line, and Call manager transfers that call to a route point, does JTAPI that monitors that route point know that I dialed 1-714-111-2222 or not? Are the original dialed numbers preserved in the clal or not?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...