have an existing set up with a vic-2fxo in a vg200,using h323 to a bogen pcm2000. works fine. i am trying to move the line to a 2821 isr with a vic2-4fxo card. config is same but when i try to access the bogen, after a few seconds, i get what sounds like a busy tone from the bogen.
from the vg200, i hear a 2-beep confirmation tone and then i'm connected through, but from the 2821 i get this constant beep tone. the dial-peer sends a 00 to the bogen, but when connected to the 2821 fxo, it sounds like the digits aren't being sent and thus the constant beeps. i've tried dialing the 00 after getting connected, but get same beeps.
any ideas? could the cards have different settings that require a different config?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...