<br>I have a Unity box (Cisco 7835) with two mirrored drives (doesn't everybody?) and I want to pull a drive and keep it as a backup. I've done this once or twice before in the distant past, and want to get the steps right. <br><br>(1) Clean shutdown<br>(2) Remove drive 1 (leaving drive 0 in place)<br>(3) Boot the box<br>(4) ...There's a prompt here, I forget what it is and what the reply should be?<br>(5) When the box is all the way up, insert new drive and watch it rebuild<br><br>Thanks in advance<br>Mark<br><br>
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...