build a simple VOIP network

[jawwalit]

hi:

i have two sites each one have a router 2811 and switch 3650-POE , i would like to build a simple VOIP network between them without need to buy a cisco call manager, how can do that (configuration) and which module i need to to add to routers. can u please give me URL that is so similar for my case

thanks

[Brandon Buffin]

You can run Callmanager Express on the routers. You could also run Unity Express on the routers for voicemail if that is a requirement. CUE comes in either a Network Module or AIM form factor. Please see the links below.

CCME Intro

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/index.html

CCME System Administrator Guide

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_book09186a00805f262e.html

Unity Express Intro

http://www.cisco.com/en/US/products/sw/voicesw/ps5520/index.html

Cisco CME/Cisco Unity Express Configuration Example

http://www.cisco.com/en/US/products/sw/voicesw/ps5520/products_configuration_example09186a008037f2a9.shtml

Hope this helps. If so, please rate the post.

Brandon

[Chris Deren]

You can also create simple network with couple of pots phones (analog phones) connected to FXS ports on the router withot the need of CM or CME, off course it's not end-to-end voip.

Chris