Bulk edit tool suddenly stopped working. Basically try running the edit tool and get error message; "Cannot log on to DOH. Unity must be running, please start Unity and try again"<br><br>Any ideas???<br><br>Thanks<br><br>Jarrod Wieland<br>Enventis<br><br>
Either the DOH interface isn't flying right (which would normally mean Unity wouldn't be working correctly) or you're logged in as an account that doesn't have sufficient rights to bind to the DOH. Try logging in as the Unity installation account and running it then and see if it flies for you.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...