Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

C2620 with BRI S/T TE, a-law - u-law problem

Hello,

I configured a 2620 router with BRI S/T TE and NM-2V voice module for VoIP applications using H.323 gateway and gatekeeper. The router runs with IOS 12.2(3).

When estabishing a call from a H.323 phone to the ISDN network the Q.931 SETUP message is encoded u-law in the Bearer Capability information element although the H323 phone generated the call with a-law and the dial-peer voice voip was configured for codec g711alaw.

The "sh voice dsp" shows "g711alaw". In European ISDN a-law is required.

Could anybody give me advice. Thanks

1 REPLY
New Member

Re: C2620 with BRI S/T TE, a-law - u-law problem

Hallo

CSCdv00152

A Cisco 2600 or 3600 series router that is running Cisco IOS Release 12.2(3) does not support the compand-type a-law command in voice-port configuration mode on the Command Line Interface (CLI) for a Basic Rate Interface (BRI) port. Therefore, it is not possible to configure the Cisco 2600 or 3600 series router to work with Integrated Services Digital Network (ISDN) BRI port with a-law. There is no workaround.

Fixed in :

12.2(4.1) 12.2(4.1)S 12.2(4.1)PI 12.2(5.2)T 12.2(4.02a)DA

Juergen

150
Views
0
Helpful
1
Replies