Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Call busy signal on VWIC 2B NT/TE

If a voice call originates in site A and the vxic 2b nt/te on site B is busy, is there any way that the busy port can send back a busy tone to the user on site A.

1 REPLY
Anonymous
N/A

Re: Call busy signal on VWIC 2B NT/TE

If you forwarding a call out a ISDN port that is

busy it should send you a no channel available in the disconnect.

If you want to re-route on any failure, however, of play a busytone, you

can configure the isdn interface to send a release cause-code of 11.

So from global mode, use the command "isdn voice-call-failure 11"

The router A would receive this when isdn cause code is release for all reasons except

Normal call clearing, User busy, No user responding

97
Views
0
Helpful
1
Replies
CreatePlease login to create content