Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

call drop Intermittently through MGCP gateway

Hi,

Calls are getting disconnect intermittently through MGCP gateway.

My voice gateway hardware config is as below.

CISCO2821-V/K9

PVDM2-32U64

PVDM2-64

two no - VWIC2-2MFT-T1/E1

Can any one help why call are getting disconnected.

Regards,

Nishit

4 REPLIES

Re: call drop Intermittently through MGCP gateway

This offers nearly 0 information.

You'll need to be more specific about how calls drop, what you hear, what shows up on your IP phone, if it has a pattern, how long it has been happening, when it started happening, what changed, what version your gateways are on, what version CUCM you're on, what type of PSTN connection you have (CAS, PRI), error messages from CUCM or the gateway, anything.

New Member

Re: call drop Intermittently through MGCP gateway

Hi,

User hear beep beep...tone when calls are getting disconnected. Users are not getting any error message on phone when calls are getting disconnected. User has to redial the call.

Calls are getting disconnected intermittently. There are three E1 PRI terminated on VWIC2-2MFT-T1/E1 card. MGCP gateway's ios part no is S28NSPSK9-12403

cisco 2800 SP services. cucm version is 5.1.3c

I don't know how to check any error message related to pri line in call manager. I had observed sometime layer 2 of all three pri lines flaping, but i am not sure whether calls are getting disconnected due to layer 2 flapping or is there any problem in the config of the mgcp gateway or call manager.

Herewith i am attaching config of mgcp voice g/w and debug output.

Pl observe and help if you found anything wrong.

Regards,

Nishit

Re: call drop Intermittently through MGCP gateway

Looks like your provider is having issues:

*Dec 18 09:11:46: ISDN Se0/1/1:15 Q931: RX <- DISCONNECT pd = 8 callref = 0x8A4C

Cause i = 0x82A9 - Temporary failure

*Dec 18 09:11:46: ISDN Se0/1/1:15 Q931: TX -> RELEASE pd = 8 callref = 0x0A4C

*Dec 18 09:11:46: ISDN Se0/1/1:15 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x8A4C

Cause i = 0x82A9 - Temporary failure

Temporary failure is a non-standard disconnect cause, and means internal failure in the provider network.

New Member

Re: call drop Intermittently through MGCP gateway

Hi Nicholas,

Actually I have the disconnect issue for inbound and outband call, I think the problem is with the  "Cause i = 0x82A9 - Temporary failure" logg, which is presents when I activated the debug isdn q931.

The topology is  PSTN-GW28XX-CCM5.1 . I talked about that and I showed the messages to Telco´s technician, but He say this´snt a problem, but I think this is not correct...

We have only one E1-PRI on gateway, and we have 51 "Temporary failure" events over a period of 36 hours including inbound and outbound calls.

Do you have any tips about root cause by the telco side or what thing they could review to find the cause.

Thanks a lot.

Ivan Garrido.

1537
Views
0
Helpful
4
Replies
CreatePlease to create content