Call Drop with ip Phone 7910 (without switch)

[langbob]

In my switch WS-C3524-PWR , i have a LOT of message :

Feb 28 10:05:10.982: %LINK-4-ERROR: FastEthernet0/4 is experiencing errors

When many message appear , the phone drop the call or when we hang up the handset no dial......

I dont have this problem with the 7940,7960 or 7910sw , because the speed is 100Mbs Full Duplex.... With the 7910 he work at 10Mb Half duplex and cause a lot of collision , Input Errors and Frame errors etc etc etc......

Ex:

5 minute output rate 6000 bits/sec, 9 packets/sec

394674 packets input, 174753356 bytes

Received 12831 broadcasts, 0 runts, 0 giants, 0 throttles

48695 input errors, 0 CRC, 48695 frame, 0 overrun, 0 ignored

0 watchdog, 12145 multicast

0 input packets with dribble condition detected

23381478 packets output, 2721655713 bytes, 0 underruns

0 output errors, 48030 collisions, 3 interface resets

0 babbles, 0 late collision, 2928 deferred

0 lost carrier, 0 no carrier

thank you

Bobby

[kthorngr]

Hi Bobby,

Have you tried hard coding your switch port with the 7910 to 10MB/Half Duplex?

HTH,

Kev

[aattravi]

I have the same problem.

There is not a solution........

the 7910 is a terrible (!) phone!

you can try to set a speed and mode on switch port.

Bye

[langbob]

I set the port to 10 Mbs Half-duplex in the swith, i have the same result....

yes the 7910 is a terrible phone .....

Thank's