Situation: I have my IP-Phone with the Number 020 555 66 77.
Official Head Number is 020 555 66 70, so the DDI is from 70 to 79.
Now, i forward my Number to my mobile Phone with the Number 020 666 77 88.
Problem: On my mobile Phone, i see always the Head Number, so the 020 555 66 70 but i like to see the Number of the person who calling me. I'll be also happy, if i can see the Number of my IP-Phone. I like to have one of this two possibilities.
We use CM 4.1(3)sr3a and the Gateway is H.323 on a Cisco 1760 Router with IOS ip-voice 12.3(14)T7
Make sure that you have a value entered for the external phone number mask field in DN configuration in CCM admin. For your phone, you could make it 020 555 66 77. Also, on your route patterns, make sure that the box that says "Use Calling Party's External Phone Number Mask" is checked.
Also check under Gatweay configuration in CCM admin. For example, if this is a PRI, you will see a field called Caller ID DN under Outbound Calls in the configuration for the endpoint. This overrides any other caller ID for calls routed out this endpoint.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.