Re: Call Forwarding to PSTN with an ATT&T Pin code
I cannot think of anyway to meet your customer's requirement with CallManager alone. However, depending on the gateway type and trunk type you may be able to hack something up--a quick thought I had was to use an H.323 gateway and to translate the called number to add ,,1234 (assuming 1234 is the code) at the end.
The success of this would be dependant on the trunk type, though; if the trunk was a PRI, the called number would be sent during call setup and it would I cannot think of a way to have the gateway interject the code in to the actual voice path.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4