I am trying to set up the following. Incoming DDI number is rerouted back out to an external number. I have created a CTI route point 8901 which is the last 4 digits of the DDI and set Call Forward All and entered the outside number. Problem is when i call in i get number is out of service message.
I am pretty sure it CSS and Partition but cant seen to work it out, anyone have a good link?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.