We have set up the Operator handler to go a ext. When we enter voice mail we hit the 0 key to go to the extension and get message "operator is not available at this time" if we leave a message and then press 0 we get the ext. we programed into the call handler...anyone have any solutions to are problems. (all other keys work to skip greeting and exit out to another ext)
where are you entering the voice mail system? The opening greeting? I'll be tthe "0" key on that call handler is setup for "send to greeting for" the operator call handler instead of the "attempt transfer for" the operator call handler like you want.
You can change this behavior in bulk for all call handlers/subscribers using Bulk Edit if you need to.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...