Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Call Handler - System greeting prompt at end of user recorded greeting.

I have many user greetings recorded where I simply want the system to beep after my greeting is complete and I do not want the system to say:

You may record your message at the tone. When you are finished you may hang up or hold for more options.

In fact I do not have more options for them. After they record a message I hang up on them. What do I do to get rid of this system message on Call Handlers?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Call Handler - System greeting prompt at end of user recorde

You can remove that prompt entirely system wide by replacing it with a bit of silence... be aware this is not TAC supported and the silent prompt will be over written again with the original during an upgrade and you'll have to do this again... that said, here's a link to a post with the details:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&type=bookmarks&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.ee83e4c/0#selected_message

1 REPLY
Cisco Employee

Re: Call Handler - System greeting prompt at end of user recorde

You can remove that prompt entirely system wide by replacing it with a bit of silence... be aware this is not TAC supported and the silent prompt will be over written again with the original during an upgrade and you'll have to do this again... that said, here's a link to a post with the details:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&type=bookmarks&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.ee83e4c/0#selected_message

93
Views
0
Helpful
1
Replies