Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

call handling via a CM for the PBX

Hey,

does anyone got an idea for this problem?

A call coming in should go cross the PBX over a gateway to the CM where the customer leaves the number where he is presented on the PBX or anywhere else...

One method would be to use a hdv interface to open two voice connections - one from the PBX to the CM and one from the CM to the PBX (verry expensive solution!!) any other solutions???

Thx and best regards

joerg

1 REPLY

Re: call handling via a CM for the PBX

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources online at http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

229
Views
0
Helpful
1
Replies