Call Hold, Call Transfer, Call Pickup, Group Pickup
which features (Call Hold, Call Transfer, Call Pickup, Group Pickup)is supported by Cisco CallManager version 4.1(3) when using analog phone is attached to VIC-2FXS inserted into NM-2V module of Router 2620XM. This router is running H.323 and was configured as a line gateway H.323 on CallManager 4.1(3).
Re: Call Hold, Call Transfer, Call Pickup, Group Pickup
When MGCP is used, the Cisco CallManager controls routing and tones and provides supplementary services to the gateway. MGCP provides call preservation (calls are maintained during failover and failback), redundancy, dial plan simplification (no dial peer configuration is required on the gateway), hookflash transfer, and tone on hold. MGCP-controlled gateways do not require an MTP to enable supplementary services such as hold, transfer, call pickup, and call park.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...