Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
220
Views
0
Helpful
1
Replies

Call Manager 3.0 SMDI Integration with Octel 350 via VG248 gateway

muvavarirwar
Level 1
Level 1

‎07-19-2002 06:37 AM - edited ‎03-12-2019 07:59 PM

What are the exact cable specifications and pin-outs required to inter-connect CCM to an Octel 350VM server using SMDI via the VG248 Analog Gateway.

The SMDI Integration link 'originates' from the Async port of the VG248 and 'terminates' at a DB25 male connector attaching to the Octel 350VM.

What are the Pin-Outs on both ends?

What are the Cisco part numbers (for cable) required?

Labels:
0 Helpful
1 Reply 1

ciscomoderator
Community Manager
Community Manager

‎07-26-2002 07:31 AM

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

0 Helpful
Customers Also Viewed These Support Documents