Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Call Manager 3.2.1b and Call Transfer Methods

I'm trying to find out what Call Transfer Methods are supported, e.g. FLASHHOOK, DTMF Only, etc...

2 REPLIES

Re: Call Manager 3.2.1b and Call Transfer Methods

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Cisco Employee

Re: Call Manager 3.2.1b and Call Transfer Methods

With an IP phone you can only use dtmf. So you would hit transfer and dial the digits then you can hit transfer or wait for the other party to answer then hit transfer. With fxs ports on like a vg248, vg200, or other IOS gateway you can do a flashhook. I think the 6624 supports this as well just not %100.

Thank you,

-Mckee

104
Views
0
Helpful
2
Replies