01-23-2003 12:03 PM - edited 03-12-2019 10:24 PM
Where in the Call Manager do I configure SRST so it lets the phones know what router using SRST.
01-23-2003 02:02 PM
SRST is configured on your IOS gateway, not in call manager. Your IP phone has to have a phone load that supports SRST as well. If you are running CM 3.1(3a) or higher, you should be ok.
In the gateway, the command is
router(config)#call-manager-fallback
ip source-address
01-23-2003 03:22 PM
I stand corrected, it looks like in CCM 3.3, you can define a device other then your LAN GW as a SRST device!
Very interesting....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: