We currently have a copy of GFI Faxmaker 12 running on our network. It's just hooked up to a Multitech modem which is connected to a ATA186/188. Everything works fine, but some of the higher-ups have expressed an interest in DID routing on the faxes. Can somebody give a recommendation on an appropriate card and possibly some general steps to configure it?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.