Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Call Manager And PBX Integration

I have a IP network in which I am running VOIP and IP telephone running.

Voip on this network is working.

For the integtation of PSTN with Iptelephone (CCM-V3.0(9)) I have configured the routers as H.323 Gateways and the H.323 gateways are registred on the CCM.

The Cisco IP telephones are able to place calls to the PSTN phones to remote location as well as noraml pstn extensions.

But at times when i dial the remote location number i am getting a cracking noise on the IP phone.

This happens after the full digits dialing.

When this noise happens, on the routers i am able to see the calls getting placed too.(Sh Voice Call Summary)

I changed with a new IP set and same problem continues.

Need help on this.

1 REPLY

Re: Call Manager And PBX Integration

Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

294
Views
0
Helpful
1
Replies
CreatePlease to create content