I have configured my callmanager as a gateway. But it is not registered with the callmanager. Status is always unknown. Could any of you please help me to resolve this problem. For your information, there is no cluster setup. I have only one callmanager.
I have configured a route plan with the route pattern 6XXX. There is no directory number configured with the starting digit 6. I expect to use the route plan whenever I dial 6XXX. But it not at all use the route pattern and route list configured over here. What could be the problem. Please help me to resolve this problem also.
After reading your post, I'm confused on what you are trying to do. You say you have one CallManager, if that is the case, why set it up as a gateway? If you are trying to setup an inter-cluster trunk to another CallManager server, it uses H.323. With that, I think it will show up as unknown. If this is the case and you are having trouble making calls between two CallManagers, please see the link below, if not, please re-describe your issue.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.