Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Call Manager providing caller information

For outbound calls, I would like to send out the calling number (DID number) to the carrier so that they can track all outbound calls that originate from the Call Manager. I have found a Clusterwide Parameter setting "Calling Party Number Screening Indicator" which provides an option for the Call Manager to provide the calling number. Would that be the right option to select and is there anything else that needs to be changed to have that information sent to the carrier?

Thank you.

3 REPLIES
Cisco Employee

Re: Call Manager providing caller information

you can simply configure whatever number you want to send to telco under the GW config. all calls routed thru the GW will go out with that ANI

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Community Member

Re: Call Manager providing caller information

What if I want to have each callers' DID number appear for outbound call? Isn't that set up in the Call Manager not the GW? Thanks again!

Cisco Employee

Re: Call Manager providing caller information

yes, configure it either in the route pattern or route group.

i never mentioned configuring the actual GW, i mentioned the GW config IN CUCM

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
137
Views
0
Helpful
3
Replies
CreatePlease to create content