Hi, I've been trying the XML functions on the 7960 with the CM-Sim. But I cannot have the IP phones register to the CM-Sim. The "State" information on CM-Sim is always "registering", but "registered". And I guess this probably is the reason why all the "NewCall" etc. softkeys are always not active. And when I post "Dial:1002" URI to the phone, it always shows "AutoDial Cancelled".
Does anybody can kindly help how to get the phones registered to the CM-Sim?
Ahh.. that would have been an important detail to mention upfront in the other thread ;) People hardly use the simulator anymore because it's so limited. Nowadays, you can easily run a ccm off a virtual machine so you can have a lab equipment without a single server.. all you need is a free virtual machine software and the software itself. CCM5 is the only problematic release as you cannot really install it and it won't run without a license, but CCM6 and above have a limited license that is enough for development and there's no licensing prior to CCM4.
I think the dial is the only function that actually works with the sim but I'm not even sure about that as I've stopped using the simulator 4 years ago and moved to a real (albeit not no a server but a regular windows box) ccm.
I guess you'll have to set up wireshark on the machine running the simulator and look at the skinny packet exchange to see if you get any kind of clue why things don't work out. E.g. one thing to look for is if the device does the TFTP request and gets its configuration, if it checks the firmware version, etc.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...